ZyXEL Communications XGS-4526 사용자 설명서

 Chapter 4 The Web Configurator

XGS-4526/4528F/4728F User’s Guide

Uploading the factory-default configuration file replaces the current configuration 
file with the factory-default configuration file. This means that you will lose all 
previous configurations and the speed of the console port will be reset to the 
default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to 
none. The password will also be reset to “1234” and the IP address to 
192.168.1.1. 

To upload the configuration file, do the following:

Connect to the console port using a computer with terminal emulation software. 
See 

 for details.

Disconnect and reconnect the Switch’s power to begin a session. When you 
reconnect the Switch’s power, you will see the initial screen. 

When you see the message “Press any key to enter Debug Mode within 3 
seconds ...

” press any key to enter debug mode.

Type atlc after the “Enter Debug Mode” message.

Wait for the “Starting XMODEM upload” message before activating XMODEM 
upload on your terminal.

After a configuration file upload, type atgo to restart the Switch.

Figure 22   Resetting the Switch: Via the Console Port 

Bootbase Version: V1.00 | 10/22/2007 12:48:50

RAM:Size = 128 Mbytes

DRAM POST: Testing:131072K OK

DRAM Test SUCCESS !

FLASH: Intel 64M

ZyNOS Version: V4.00(BBC.0)b1 | 10/14/2010 17:32:18

Press any key to enter debug mode within 3 seconds.

.....................................

Enter Debug Mode

ras> atlc

Starting XMODEM upload (CRC mode)....

CCCCCCCCCCCCCCCC

Total  393216 bytes received.

Erasing..

................................................................

OK

ras> atgo