McDATA 3032 사용자 설명서

2. Disconnect the fiber-optic cable from the SFP. Use compressed air 

to blow any contaminants from the connector as shown in part A 
of 

.

— Keep the air nozzle approximately 50 millimeters (two inches) 

from the end of the connector and hold the can upright.

— Blow compressed air on the surfaces and end of the connector 

continuously for approximately five seconds

.

3. Gently wipe the end-face and other surfaces of the connector with 

an alcohol pad as shown in part B of 

. Ensure the pad 

makes full contact with the surface to be cleaned. Wait 
approximately five seconds for surfaces to dry.

4. Repeat 

 and 

 of this procedure (second cleaning).

5. Repeat 

 and 

 of this procedure again (third cleaning), 

then reconnect the fiber-optic cable to the port.

To power on the switch:

1. One alternating current (AC) power cord is required for each 

power supply. Ensure power cord(s) are available to connect the 
switch to facility power.