Alcatel-Lucent 6850-U24X 사용자 설명서

6

Installing the Hardware

Carefully remove any foam pads and protective plastic 

from the switch chassis.

Note. Alcatel-Lucent provides factory-installed blank 
cover plates for empty backup power supply or 10-Giga-
bit expansion module bays. Do not remove these cover 
plates unless a backup power supply or expansion module 
is to be installed immediately at the corresponding bay.

If you are installing multiple switches in a stacked 

configuration, repeat steps 1 through 4 for the remaining 
switches that will make up the stack.

Once all OmniSwitch 6850 Series switches have been 

removed from their packaging, continue to “Setting Up 
the Switch.”

Note. Due to their airflow and access requirements, 
OmniSwitch 6850 Series switches cannot be wall-
mounted.

Be sure that your switch is placed in a well-ventilated, static-
free environment. Always allow adequate clearance at the 
front, rear, and sides of the switch.

The following diagram shows recommended minimum clear-
ances for adequate chassis airflow and access to components at 
the rear of the chassis:

OmniSwitch 6850-48

CLASS 1 LASER PR

ODUCT

Rear. 5 inches minimum 

at rear of chassis.

Front. 6 inches minimum 

at front of chassis for 

cable access and LED 

visibility.

Sides. 2 inches minimum 

at left and right sides for 

chassis airflow.