Lathem DDC2 사용자 설명서
Digital Display Wall Clock Guide
Page 16
DDC4 (Double Mount - Wall)
»
Remove the two phillips head screws from the left and the right end caps of the two DDC4 clocks
and remove. Slide the front panel assemblies out of the cases and set aside.
and remove. Slide the front panel assemblies out of the cases and set aside.
»
Place the two DDC4 clocks back to back and secure by inserting a #10 screw through the two key
holes and the two lower mounting holes using lock washers and nuts supplied with the mounting
kit.
holes and the two lower mounting holes using lock washers and nuts supplied with the mounting
kit.
»
Attach the modified end cap to the end of the clocks that will be attached to the wall mount plate
using the original end cap screws.
using the original end cap screws.
»
Align the holes of the end cap support plate with the holes in the modified end cap and secure with
4 #6 phillips head screws (supplied)
4 #6 phillips head screws (supplied)
»
Line the two posts from the mounting plate up with the two holes of the modified end cap. Insert
the chase nipples through the holes of the modified end cap and secure to the mounting plate with
a 15/16" wrench.
the chase nipples through the holes of the modified end cap and secure to the mounting plate with
a 15/16" wrench.
»
Slide the front panel assemblies in partially. Secure the required wiring and install the battery if
used.
used.
»
Slide the front panel assemblies in fully. Install the end caps and secure each with its two screws.
»
Discard or store the two original end caps the modified end cap replaced.
mounting plate
#10 lock washers
#10 screws
end cap support
chase nipples
modified end caps
DDC4 cases
#10 lock washers
#10 hex nuts
Figure 5