Acer G901 사용자 설명서
101
Power distribution board
Replacing the power distribution board
1
2
Open the front subchassis and remove the electronics bay (refer to
page 47 and page 49).
page 47 and page 49).
3
Partially remove the power supplies (refer to page 82) to
disengage the power supply connectors from the power
distribution board.
disengage the power supply connectors from the power
distribution board.
4
Disconnect the cables from the power distribution board.
5
Remove the four screws that secure the power distribution board
to the main chassis.
to the main chassis.
6
Grasp the edge of the power distribution board and plastic overlay
along the edge where the screw holes are located. Lift the edge,
tilting the board about 30°. Pull up on the board to free the holes
on the opposite edge from the tabs on the chassis and slide the
board free
along the edge where the screw holes are located. Lift the edge,
tilting the board about 30°. Pull up on the board to free the holes
on the opposite edge from the tabs on the chassis and slide the
board free
.
Figure 52 - Removing a power distribution board
BB!H:11!vh!.!FO/cppl!!Qbhf!212!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN