Fujitsu TX200 사용자 설명서

198

Chapter 7 Installing Hardware Options

■ Notes on Installing Expansion Cards

• Install installable expansion cards only.

• Before installing an expansion card, refer to "PRIMERGY ServerBooks" supplied with the server,

and "Supplement" supplied with options. Also, check the following for respective expansion cards.

●

Points to Note when Installing RAID Card (PG-140D1/PG-142E3)

• Connection of a SCSI device

Connect the SCSI device supported by this server. Operations are not guaranteed when an

unsupported SCSI device is connected. For details about connection patterns, refer to "

• Precautions before OS installation

In addition to the completion of RAID card configuration, the hard disk under the RAID card must be

initialized or the background initialization process must be started before the OS is installed. When

the OS is installed using ServerStart, ServerStart performs configuration and hard disk initialization

automatically.

• Installation locations

If the hard disk unit where the OS is installed is connected to the RAID card, install the RAID card in

Slot 1.

• PCI slot settings

When connecting to an external SCSI device (when not connecting with an internal hard disk unit)

after installing the RAID card (PG-140D1/ PG-142E3), set the following BIOS setting to "Disabled"

(Set to "Disabled" at time of purchase).

However, when a RAID card (PG-140D1/PG-142E3) has been installed to PCI slot 1 and connecting

to the internal hard disk units, select BIOS setup utility "Advanced" menu

→ "PCI Configuration"

sub menu

→ "PCI slot 1 Configuration Option ROM SCAN" to change the setting to "Enabled". For

When the configuration for connecting to the internal hard disk has been selected after the RAID card

was installed on an array type or customized type, the BIOS settings of PCI Slot 1 are set to

"Enabled" at the time of purchase.