Fujitsu BX900 S1 사용자 설명서
BX900 S1
Operating Manual
29
Important notes
V
CAUTION!
●
Make sure that the power sockets on the device or the grounded
mains outlets are freely accessible.
mains outlets are freely accessible.
●
The On/Off button or the main power switch (if there is one) does not
disconnect the device from the mains voltage. To completely
disconnect it, you must remove all the power plugs from the power
outlets.
disconnect the device from the mains voltage. To completely
disconnect it, you must remove all the power plugs from the power
outlets.
●
Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
a power outage occurs and the server is still running but the
peripheral device (e.g. a storage subsystem) has failed.
power circuit. Otherwise you run the risk of losing data if, for example,
a power outage occurs and the server is still running but the
peripheral device (e.g. a storage subsystem) has failed.
●
Data cables must be adequately shielded to avoid interference.
●
For the LAN wiring, the requirements according to standards
EN 50173 and EN 50174-1/2 apply. The minimum requirement is the
use of a protected LAN cable of category 5 for 10/100-Mbit/s
Ethernet, and/or of category 5e for Gigabit Ethernet. The
requirements of the specification ISO/IEC 11801 must also be taken
into account.
EN 50173 and EN 50174-1/2 apply. The minimum requirement is the
use of a protected LAN cable of category 5 for 10/100-Mbit/s
Ethernet, and/or of category 5e for Gigabit Ethernet. The
requirements of the specification ISO/IEC 11801 must also be taken
into account.
●
Route the cables in such a way that they do not form a potential
hazard (tripping) and cannot be damaged. When connecting the
device, refer to the relevant notes in the operating manual.
hazard (tripping) and cannot be damaged. When connecting the
device, refer to the relevant notes in the operating manual.
●
Do not connect or disconnect any data transmission cables during a
thunderstorm (lightning hazard).
thunderstorm (lightning hazard).
●
Make sure that no objects (such as bracelets or paper clips) or liquids
get inside the device (risk of electric shock or short circuit.
get inside the device (risk of electric shock or short circuit.
●
In emergencies (e.g. damaged casing, control elements or power
cable, penetration of liquids or foreign bodies), switch off the device
immediately, unplug it from the grounded power outlets, and contact
your customer service center.
cable, penetration of liquids or foreign bodies), switch off the device
immediately, unplug it from the grounded power outlets, and contact
your customer service center.