Fujitsu N800 사용자 설명서

U41243-J-Z156-1-76

 41

Preparation for use and operation Configuring the server and components

This switch controls whether the system attempts to boot using the BIOS code 
stored in flash memory, or, if the BIOS code is corrupt, whether a recovery boot 
is performed by loading the BIOS code from a floppy disk into flash memory.

If you want to start a recovery boot, proceed as follows:

Ê

Follow the procedure described in the section “Changing the switch 
settings”.

Ê

Set DIP switch 2 (see table 2 on page 38) to ON.

Ê

Insert the flash memory update floppy disk in drive A.

Ê

Turn on the system. 

After the system boots, a single beep is emitted and the recovery process is 
started. This takes about three minutes. Once the recovery process has 
been completed, two beeps are emitted.

During recovery, there is no screen display on the monitor and the keyboard 
is disabled. 

The following beep sequences indicate the recovery status:

Ê

Shut down the system, turn off the server and disconnect it from the line 
voltage.

Ê

Set DIP switch 2 (see table 2 on page 38) to OFF.

Ê

Remove the floppy disk from drive A.

Ê

Reconnect all the peripheral devices, reconnect the server to the line voltage 
and switch it on.

Ê

Run 

 to enter a new password (see the section “BIOS Setup” on 

2

Successful completion, no errors.

4

The system could not boot from the floppy disk. The 
disk may not be bootable.

Continuous 
series of low 
beeps

The corrupt BIOS recovery files were used, or the 
flash memory switch is in the wrong position.