Hitachi 8880R 사용자 설명서

Referring to the manual of the extended board, either choose or enter the appropriate values. If some value overlaps 
with the value of an existing extended board, an error message is displayed. After changing the settings for the 
existing extended boards, make settings for each resource.

This utility automatically reserves higher 6-bit addresses by reserving lower 10-bit I/O address area. Although some 
manuals related to the communication board (PC-CH2100) explain that four 16-bit addresses should be reserved, 
you can load the configuration file recorded within the utility and then specify the lower 10 bits according to the 
procedure.

You can change settings in the extended board in use to change the values for the resources in use. This should be 
done when:

•

You want to use resources that are being used by an extended board already installed.

•

You want to change setting values.

NOTE: When you need to install an extended board in or remove it from the system equipment, call the 

maintenance personnel.

Remove the extended board in advance.

After changing the settings, you need also to change the settings for short pins on the extended board. See the 
vendor manual of the extended board.

Start the ICU.

In the [ISA Configuration Utility] window, select the board to be changed, and choose the [Modify] button.

Communication board
Motherboard System Devices
PCI Card:  VGA Controller
PCI Card:  SCSI Controller
PCI Card:  Unknown Card
PCI Card:  IDE Controller

ISA Configuration Utility

File  Configure  View  Advanced  Help

Card Configured In System:

Add

Remove

Modify

View