Perle Systems 5500161-40 사용자 설명서

Adding/Editing Users

206 

IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0

When the 

 is 

, this is the target port number. The default 

value will change based on the type of 

 selected; the most common 

known port numbers are used as the default values.

Used for 

 or 

, sets the IP address of the remote user. 

Enter the address in dot decimal notation as follows:

z

—(where 

 is a number) Enter the IP address of your choice. This 

IP address will then be used in preference to the 

 set 

for a line.

The following IP addresses have a special meaning:

z

—The IOLAN will use the 

 set in the 

 settings for the serial port that this user is connecting to.

z

—When the 

 is 

, the IOLAN will allow 

the remote machine to specify its IP address (overriding the IP address 
negotiation value configured in the 

 settings).

z

—When the 

 is 

, the IOLAN will use 

the 

 set for the line (no negotiation).

Default: 255.255.255.254

If the remote user is on a subnet, enter the network’s subnet mask. For 
example, a subnet mask of 255.255.0.0.

Used for 

, sets the IPv6 address of the remote user. Enter the 

address in IPv6 format. 

Field Format: The first 64 bits of the Interface Identifier must be zero, 
therefore, ::abcd:abcd:abcd:abcd is the expected format.

Used for 

 

 or 

, specifies the maximum size of packets, in 

bytes, being transferred across the link. On noisy links it might be preferable to 
fragment large packets being transferred over the link, since there will a be 
quicker recovery from errors. 

z

—

 will be the maximum size of packets that the IOLAN will 

negotiate for this port. This value is negotiated between the two ends of 
the link. 

z

—

 will be the maximum size of packets being sent by the 

IOLAN. 

The 

 value will override the 

/

 values set for a 

.

Range: PPP: 64-1500 bytes, SLIP: 256-1006 bytes

Default: PPP is 1500 bytes, SLIP is 256 bytes

Determines the routing mode used for RIP packets on the 

 and 

 

interfaces. Values are:

z

None—RIP packets are neither received nor sent by the IOLAN.

z

Send—RIP packets can only be sent by the IOLAN.

z

Listen—RIP packets can only be received by the IOLAN.

z

Send and Listen—RIP packets are sent and received by the IOLAN.

Default: None