Fujitsu S510M 사용자 설명서
16
2.2
Connecting ScanSnap to your Computer
Follow the procedure below to connect ScanSnap to your computer.
1. Connect ScanSnap to a power outlet with the AC cable.
2. Connect ScanSnap to your computer with the USB cable.
2. Connect ScanSnap to your computer with the USB cable.
The following describes each of the above-mentioned two procedures.
■ Connecting the AC Adapter
Connect the power cable as shown below.
CAUTION
Do not use AC adapters other than the following.
Operation
1.
Connect the AC cable to the AC adapter (collectively called the power cable)
2.
Plug the AC adapter to the AC adapter connector on the back of ScanSnap and the
other end to a power outlet as shown in the figure.
other end to a power outlet as shown in the figure.
ATTENTION
•
Be sure to connect the AC cable before connecting the USB cable.
•
Be sure to install ScanSnap Manager before connecting ScanSnap to your
computer. [For details about the installation, refer to "Installing ScanSnap"
(page 6)].
computer. [For details about the installation, refer to "Installing ScanSnap"
(page 6)].
Manufacturer
AC-adapter model number
LEI
NU40-2160250-I3
SANKEN ELECTRIC CO,. LTD
SEB55N2-16.0x (x= A-Z or Blank)
ATTENTION
Use only the supplied AC cable and AC adapter (power cable).
AC cable
AC adapter