Fujitsu fi-4640S 사용자 설명서
7-2
Contents of the Setup Mode
This section describes the contents of the setup mode.
N
o
Item
Description
Selectable
parameters
parameters
Default
1
Double feed check
Specifies the double feed detection. Double
feed is detected by checking the document
feed is detected by checking the document
length and/or paper thickness.**
No/Yes
No
2
Length check
=No/10/15/20 mm
Specifies the document length to enable
double feed detection sets the document
double feed detection sets the document
length.
Tolerance:
No/10/15/20mm
No
3
IPC pre-setting
Scanner automatically sets the
recommended reading parameters. 3 sets
of parameters are available when IPC-4D is
not installed.
Document:
No
1: Sharpen
No
1: Sharpen
2: Darken Character
3: Copy Quality
3: Copy Quality
No
4
Resetting of
abrasion counter
Resets the abrasion counter.
---
---
5
Pick start time
setting
Specifies the time from document Insertion
to the start of picking. User can select the
to the start of picking. User can select the
most comfortable Pick start time for the job.
Time:
0.2 to 29.8 sec
0.2 to 29.8 sec
1.0 sec
6
Time-out limit setting
Specifies the time the scanner waits for the
next document insertion after the last
document was scanned.
next document insertion after the last
document was scanned.
Time:
27 values from
27 values from
1 to 1999 sec
30 sec
7
ADF offset setting*
Specifies the horizontal and vertical offset
of the image when using the ADF.
of the image when using the ADF.
Offset:
H:-2 to +3 mm
V:-2 to +3 mm
Offset:
H: 0 mm
V: 0 mm
8
Flatbed offset
setting*
Horizontal and vertical offset of the FB
image is specified.
image is specified.
Offset:
H:-2 to +3 mm
V:-2 to +3 mm
Offset:
H: 0 mm
V: 0 mm
9
Option (IPC/Imprinter)
status display
status display
Displays the type (IPC-4D) of the IPC
option. "IPC PRT" is displayed when the
fi-475PR Imprinter Option is installed.
fi-475PR Imprinter Option is installed.
---
---
10
SCSI ID setting
The SCSI ID is selectable. Note that the
new setting is made valid after power is
turned off and on again.
SCSI ID:
0/1/2/3/4/5/6/7
0/1/2/3/4/5/6/7
5
11
SCSI terminator
setting
setting
Switches the SCSI terminator On/Off.
On/Off
On
12
Low Power Mode
setting
Changes the default setting of the duration
for power save.
for power save.
5 min.
to 60 min.
to 60 min.
15 min.