Metrologic Instruments MS1890 사용자 설명서

 

 

11

I

NSTALLING THE 

S

CANNER TO THE 

H

OST 

S

YSTEM

 

 

Full Speed MS1890-40 
Low Speed MS1890-38  

 
1.  Turn off the host device. 

 

2.  Plug the male 10-pin RJ45 end of the 

USB cable into the 10-pin socket on  
the MS1890.  There will be an audible 
click when the connector lock engages. 

 
3.  Slide the protective cable boot up the 

cable, over the connector and onto the 
end of scanner handle. 

 

4.  Plug the USB type A end of the USB 

cable into the host’s USB port. 

 

5.  Turn on the host device. 
 
6.  The MS1890 will start to initialize.   

All LEDs (yellow, white, and blue) will 
light for approximately 2 seconds then 
start to alternately flash.  When the 
scanner has finished initializing the 
LEDs will stop flashing and the unit 
will beep 3 times indicating that the 
scanner is ready for use.  

 
 

As a default, the MS1890-38 leaves the factory with USB Keyboard 
Emulation Mode enabled. 

 

For information on configuring the MS1890-38 for USB Serial Emulation 
Mode, please refer to the USB section of the MetroSelect Single-Line 
Configuration Guide (

MLPN

 00-02544). 

   

Plugging the scanner into a port on the host device does not guarantee 
that scanned information will be communicated properly to the host 
device.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.