Epson ES-800C 사용자 설명서

You must also set the terminator switch to on or install an

external terminator on one of the two SCSI connectors on

your scanner if the scanner is the last device in the chain.

See your scanner documentation for more information on

terminators.

If you have additional SCSI devices, make sure only the last

device in the daisy chain is terminated. Use cables with

50-pin connectors at both ends, then fasten the connectors

to the scanner and the next device with the clamps on the

sides of the connector.

3. With a SCSI adapter, always turn on the scanner first; then

start the computer.

time. 

The factory-set SCSI ID of the scanner is 2. The SCSI host

adapter in the computer is normally preset to ID number 7. If

you are going to add the scanner to a system in which one of

your SCSI devices already has a SCSI ID of 2, change the ID

number of the scanner to an unused number as described next:

1. Locate the SCSI ID switch next to the SCSI connectors on the

rear panel of the scanner.

1-8 Installing the Interface Card