Uniden UBC93XLT 사용자 설명서

19

To power the scanner from a vehicle's 9.0-29V 
power source (such as a cigarette-lighter socket), 
you need a cigarette-lighter adapter.

To connect a DC cigarette-lighter power cable, insert 
its barrel plug into the DC 6V jack on the side of the 
scanner, then plug the power cable into your vehi-
cle's cigarette lighter socket.

Note: If you use a cigarette-lighter power cable and 
your vehicle's engine is running, you might hear 
electrical noise from the engine while scanning. This 
is normal.

Caution: DC 6 V Jack can use a power source that 
supplies 9.0-29V DC at least 800mA. 

You must use a power source that supplies 9.0-29V 
DC and delivers at least 800mA. Your standard 9.0-
29V car battery should be sufficient. The cord con-
nector's center tip must be set to positive and its 
plug must fit the scanner's DC 6 V jack. The sup-
plied DC power cord meets these specifications. 
Using a power cord that does not meet these specifi-
cations could damage the scanner or the adapter.

•

Always connect the adapter or DC power cord to 
the scanner before you connect it to the power 
source. When you finish, disconnect the adapter 
or DC power cord from the power source before 
you disconnect it from the scanner.

•

For added safety and to pro-
tect your scanner, discon-
nect the cable from your 
vehicle battery's negative (-) 
terminal before you begin.

UBC93XLT Paper OM.fm  Page 19  Monday, May 14, 2007  9:01 AM