Uniden BC250D 사용자 설명서

61

There are a number of ways to step and move through your
Scan List memories:

1. Press HOLD/MAN in the ID Scan mode and rotate the

VFO to move to up or down.

2. Or, press HOLD/MAN in the ID Scan mode, next press 

0-9 (scan list number), then press 0-9 (memory position).
For example to move to Scan List 4, memory position 10,
press: HOLD/MAN, 4, 0, HOLD/MAN

Set Activity ID to ON, when your scanner finds an active ID
during a transmission the active ID appears every 0.5
seconds.

I-Calls are direct unit-to-unit transmissions that are not heard
by other system users. Your BC250D can receive these
transmissions. How you receive I-Calls depends on whether
you are in Search or Scan mode.

During I-Call reception the display will show the Unit ID
number of either the transmitting or receiving mobile unit, not
a talkgroup. Unit IDs will display differently according to the
type of trunked system, and will replace the n's shown here.

EDACS and MOTOROLA TYPE 1

innnnn

MOTOROLA TYPE 2

7nnnnn

Hint -- There are thousands of Unit IDs in typical systems,

but relatively few I-Calls at a given moment, so it is
normally best to let the scanner receive any I-Calls
without trying to specify particular units.

In Search mode, the scanner default is that I-Call reception is
OFF. This means that I-Calls will not be received until you
program them to be ON. You have three choices for
controlling I-Call reception. Through the Menu system, go to
2:SCAN OPTION / 2:TRUNK - select bank number -/
8:I-CALL, and make your selection. 
The menu choices are:

1

OFF

Not received Received normally

This is the BC250D default

2

ON

YES

Received normally

Use this choice to receive I-Calls 
together with normal 
talkgroup traffic.

3

ONLY YES

NOT RECEIVED

Use this setting to listen to I-Calls, 
and block all talkgroup reception. 

For quick access to this mode, 
press       (decimal) then RSM. 

BC250D  11/6/2 11:37 AM  Page 61