Uniden BCD396T 사용자 설명서

34

3. Replace the cover.

When 

 flashes and the scanner beeps every 15 

seconds, replace both batteries.

You can also use two rechargeable batteries to power 
your scanner. Before you use rechargeable batteries, 
you must charge them.

The scanner has a built-in circuit that lets you 
recharge batteries while they are in the scanner. 
To charge the batteries, set REG. ALK. BATT./NI-MH. 
BATT. inside the battery compartment to NI-MH. 
BATT., install the batteries in the scanner, and connect 
the supplied AC adapter to the scanner's DC 6V jack 
(see “Using AC Power” on Page 35).

 

Do not connect the AC adapter to the scanner if 
non-rechargeable batteries (such as alkaline 
batteries) are installed in the scanner and REG. 
ALK. BATT./NI-MH. BATT. is set to NI-MH. BATT. , 
or if you are unsure of the switch's position. 
Non-rechargeable batteries can get hot and can 
even burst if you try to recharge them.

Before you use rechargeable batteries for the first 
time, charge them for 14 hours to bring them to a 
full charge. Discharged batteries take about 14 
hours to fully recharge.