Uniden SC230 사용자 설명서

26

Before you use rechargeable batteries for the first time, 
charge them for 14 hours to bring them to a full charge.

Discharged batteries take about 14 hours to fully 
recharge.

You can power the scanner using the supplied 6V, 
500 mA AC adapter.

To use the scanner on AC power, plug the AC adapter 
into a standard AC outlet.

If rechargeable batteries are installed and REG. ALK. 
BATT./NI-MH. BATT. is set to NI-MH. BATT., the adapter 
powers the scanner and recharges the installed batteries 
at the same time.

To attach the supplied stub antenna to the connector on 
the top of your scanner, align the slots around the 
antenna's connector with the tabs on the scanner's BNC 
connector. Then slide the antenna's connector down over 
the scanner's connector and rotate the antenna 
connector's outer ring clockwise until it locks into place.

The scanner's BNC connector makes it easy to connect a 
variety of optional antennas, including an external mobile 
antenna or outdoor base station antenna.

Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable 
to connect an outdoor antenna. If the antenna is over 50 
feet from the scanner, use RG-8 low-loss dielectric 
coaxial cable. You can get a BNC adapter at your local 
electronics store.

SC230 Paper OM.fm  Page 26  Wednesday, October 6, 2004  10:51 AM