Uniden SC230 사용자 설명서
57
Programming/Editing Optional Settings
Notes:
• If you select 0, the scanner stays on the system for a
minimal time (only long enough to check current
system activity).
system activity).
• The default setting is 2 seconds for each system.
• All unlocked channels will be scanned at least once
• All unlocked channels will be scanned at least once
regardless of this setting.
• The scanner moves to the next system after the hold
time expires, any current transmission ends, and the
channel delay time expires.
channel delay time expires.
Setting the Channel Delay Time
program system
E
Select the system
E
Edit Sys Option
E
Set DELAY Time
E
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press E.
Notes:
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press E.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.
• This setting applies to all channels within the system.
Setting Data Skip
program system
E
Select the system
E
Edit Sys Option
E
Set DATA SKIP
E
This setting controls how the scanner behaves when it
stops on a channel that has a data signal.
stops on a channel that has a data signal.
On
- the scanner stops briefly on the channel, but then
immediately resumes scanning automatically. Press E to
select.
select.
Off
- the scanner remains on the channel until the
transmission stops. Press E to select.
Menu
Menu
SC230 Paper OM.fm Page 57 Wednesday, October 6, 2004 10:51 AM