Uniden UBC396T 사용자 설명서

58

(Master scanner) Clone Master Press SCAN Key 

 

(Slave scanner) Clone Slave Press SCAN Key 

 

When you are ready to clone the scanner, press 

 

on the slave scanner first, then on the master scanner. 
The master scanner checks the connection between the 
two scanners, then transfers its data to the slave scanner. 

When the transfer is complete, Complete appears on 
both scanners. If the transfer did not work, Error 
appears on the master scanner.

You can clone (copy) data from a PC to a BCD396T 
scanner. This is useful if you want to quickly program 
20 or more BCD396T scanners at the same time.

Note: On-air cloning is practical if you are 
programming more than 10 scanners at the same 
time. Otherwise, we recommend you use wired 
programming.

 

 

 Xfer Information 

  

 

On-Air Clone 

  

• Start Cloning Start on-air cloning.

• Set Frequency  Lets you set the frequency where 

your scanner receives the cloning broadcast.

• Set Modulation Lets you set the cloning 

broadcast’s modulation type.

To clone (copy) data from a PC to the scanner, you 
need a transceiver, a PC that has an audio input, and 
a cable to connect your PC’s sound card to the 
transceiver. Follow the directions supplied with the 
Uniden Advanced Scanner Director Software (avail-
able online at http://www.uniden.com) to construct a 
cable and use on-air cloning.

When you are receiving the cloning broadcast and are 
ready to clone the scanner, select Start Cloning