Nikon COOLPIXP7100 사용자 설명서
E107
Re
fere
fere
nce
S
ect
io
io
n
Error Messages
The following table lists the error messages and other warnings displayed on the
monitor, as well as the solutions for dealing with them.
monitor, as well as the solutions for dealing with them.
Display
Description
Solution
A
O
(blinks)
(blinks)
Clock not set.
Set date and time.
N
Battery exhausted.
Battery exhausted.
Battery exhausted.
Charge or replace the battery.
P
Battery temperature
high
Battery temperature
high
Battery temperature is
high.
high.
Turn off camera, and allow battery to
cool down before resuming use. Five
seconds after this message appears,
the monitor is turned off, and the
power-on lamp, the AF/access lamp
and the flash lamp flicker. After the
lamps blink for three minutes, the
camera turns off automatically, but
you can also press the power switch
to turn it off manually.
cool down before resuming use. Five
seconds after this message appears,
the monitor is turned off, and the
power-on lamp, the AF/access lamp
and the flash lamp flicker. After the
lamps blink for three minutes, the
camera turns off automatically, but
you can also press the power switch
to turn it off manually.
P
The camera will turn off
to prevent overheating.
The camera will turn off
to prevent overheating.
Inside of the camera
has become hot. The
camera turns off
automatically.
has become hot. The
camera turns off
automatically.
Leave the camera off until the inside
of the camera has cooled and then
turn it on again.
of the camera has cooled and then
turn it on again.
–
P
Please wait for the
camera to finish
recording.
Please wait for the
camera to finish
recording.
Camera cannot
perform other
operations until
recording is complete.
perform other
operations until
recording is complete.
Wait until message clears from
display automatically when
recording is complete.
display automatically when
recording is complete.
–
N
Memory card is write
protected.
Memory card is write
protected.
Write-protect switch
of the memory card is
in “lock” position.
of the memory card is
in “lock” position.
Slide the write-protect switch to
“write” position.
“write” position.
–
N
Not available if Eye-Fi
card is locked.
Not available if Eye-Fi
card is locked.
Write-protect switch
of Eye-Fi card is in
“lock” position.
of Eye-Fi card is in
“lock” position.
Slide the write-protect switch to
“write” position.
“write” position.
–
Error accessing Eye-Fi
card.
card.
• Use an approved card.
• Check that connectors are clean.
• Confirm that memory card is
• Check that connectors are clean.
• Confirm that memory card is
correctly inserted.