Nikon COOLPIXP7100 사용자 설명서

Features That Can Be Set Using the Multi Selector

Sh
ooting Feat

ures

You can shoot pictures with a flash by raising the built-in flash. You can set a flash 
mode that suits the shooting conditions.

Press the 

K

 (flash pop-up) button to raise the flash (

• When the flash is lowered, the flash mode is fixed at W (off ).

Press 

H (m flash mode) on the multi selector.

Press the multi selector to select the desired 
mode and press the 

k button.

• See “Available Flash Modes” (

information.

• When the manual flash is selected, press 

K before 

pressing the 

k button and select the flash output.

• When Y (slow sync) or Z (rear-curtain sync) is 

selected for flash mode, the flash mode can be 
switched by pressing 

K before pressing the k button.

• If the 

k button is not pressed within a few seconds, the 

selection is set and the setting menu disappears.

• When U (auto) is applied, D is only displayed for a few seconds even if monitor 

indicators (

A15) are turned on.

Frame the subject and take a picture.

• The flash lamp indicates the status of the flash when 

the shutter-release button is pressed halfway.

- On: The flash will fire when you press the shutter-

release button all the way.

- Blinking: The flash is charging. The camera cannot 

take pictures.

- Off: The flash will not fire when a picture is taken.

• If the battery is low, the monitor will be turned off while 

the flash is charging.

C

When not using the flash, gently push to lower the flash until it clicks shut (

C

The built-in flash has a range of about 0.3 to 9.0 m (1 ft to 29 ft) for wide-angle position, and about 
0.3 to 4.5 m (1 ft to 14 ft) for telephoto zoom position (when ISO sensitivity is set to Auto).

Flash mode