Siemens TP177B 사용자 설명서
Automation and Drives - SCE
T I A Training Document
Page 60 of 129
Module
F6
Issued: 02/2008
Operator Control with WinCC flexible 2005
Preface Installation Project Description Step7 Project HMI Station WinCC flexible Projekt Messages Recipes User Management
6.3.2
Setting the MPI Address
To set the MPI address on the panel, click on “S7 Transfer Settings“
Select MPI and click on Properties.
To set the MPI address on the panel, click on “S7 Transfer Settings“
Select MPI and click on Properties.
Place a checkmark at “Panel is the only master on the bus“.
Assign the MPI Address 1 and confirm with OK.
Note
Many panels allow data transfers only if either the panel or the programmer is set as the only master
on the bus.