Dacor IF36 사용자 설명서

7

Connect the ice maker to the water supply as instructed in 
the installation instructions. Proper water flow and a level 
refrigerator are essential for optimal ice maker performance.

• Confirm ice bin is in place and ice 

maker arm is down.

• After freezer section reaches 

between 0° to 2° F (-18° to -17° 
C), ice maker fills with water 
and begins operating. You will 
have a complete harvest of ice 
approximately every three hours.

• Allow approximately 24 hours after installation to receive first 

harvest of ice.

• Discard ice created within first 12 hours of operation to assure 

system is flushed of impurities.

• Stop ice production by raising ice maker arm until click is heard.

• Ice maker will remain in the off position until arm is pushed 

down.

• The first one or two batches will probably contain undersized 

and irregular cubes because of air in the supply line.

• When the ice cubes are ejected it is normal for several cubes to 

be joined together at the ends. They can easily be broken apart. 
The ice maker will continue to make ice until the supply of ice 
cubes raises the ice maker arm, shutting the ice maker off.

• Certain sounds may accompany the various cycles of the ice 

maker. The motor may have a slight hum, the cubes will rattle 
as they fall into an empty storage pan and the water valve may 
click or “buzz” occasionally.

• If the ice is not used frequently, the ice cubes will become 

cloudy, shrink, stick together and taste stale. Empty the ice 
storage bin periodically and wash it in lukewarm water. Be sure 
to dry the bin thoroughly before replacing it.

• Beverages and foods should not be placed in the ice storage 

bin for quick chilling. These items can block the ice maker arm, 
causing the ice maker to malfunction.

• Turn off (arm up) the ice maker when the water supply is to be 

shut off for several hours.

• Pull it forward, away from the ice maker. To avoid the ice maker 

dumping ice while the bin is removed, turn the ice maker off by 
raising the icemaker arm.

• Reverse the above procedure. Turn the ice maker on by 

lowering the ice maker arm.

To avoid personal injury or property damage, observe the 
following:
•

Do not place fingers or hands on the automatic ice making
mechanism while the refrigerator is plugged in. This will 
help protect you from possible injury. It will also prevent 
interference with moving parts of the ejector mechanism 
and the heating element that releases the cubes.

•

Under certain rare circumstances, ice cubes may be 
discolored, usually appearing with a green-bluish hue. The 
cause of this unusual discoloration can be a combination 
of factors such as certain characteristics of local waters, 
household plumbing and the accumulation of copper salts 
in an inactive water supply line which feeds the ice maker. 
Continued consumption of such discolored ice cubes may 
be injurious to health. If such discoloration is observed, 
discard the ice cubes and contact your dealer to purchase 
and install a water line filter.

•

Water damage due to improper water connection may 
cause mold/mildew growth.

•

Clean up water and ice spills to avoid personal injury and to 
prevent mold/mildew growth.

The Water Dispenser is located on the left 
side wall of the fresh food section. This 
design is for cold water dispensing only.

To Dispense Water:
• Hold container under spout and press 

dispenser pad.