DELL MD3220 사용자 설명서

Troubleshooting: Your Storage Array Software

1 On the Logical tab of the AMW, select one of these virtual disks, and go to 

the indicated step:
• Snapshot virtual disk—Go to step 2.
• Snapshot repository virtual disk—Go to step 3.
• Source virtual disk—Go to step 4.
• Target virtual disk—Go to step 5.

2 Select View Go To Snapshot Virtual Disk. 

The selection jumps to the associated snapshot virtual disk in the Logical 

pane. 

3 Select View Go To Snapshot Repository Virtual Disk.

The selection jumps to the associated snapshot repository virtual disk in 

the Logical pane. 

4 Select View Go To Source Virtual Disk.

The selection jumps to the associated source virtual disk in the Logical 

pane. 

5 Select View Go To Target Virtual Disk. 

If the source virtual disk has more than one associated target virtual 

disk, select the target virtual disk that you want from the list, and click OK.

The selection jumps to the associated target virtual disk in the Logical pane. 

A storage array can have an Unresponsive status for several reasons. Use the 

procedure in this topic to determine a possible cause and solution. 
MDSM can take up to five minutes to detect that a storage array has become 

unresponsive or becomes responsive again. Before completing this procedure, 

make sure that you wait some time before you decide that the storage array is 

still unresponsive.

book.book  Page 229  Monday, June 21, 2010  11:00 AM