DELL MD3220 사용자 설명서

Troubleshooting: Your Array

1 Verify that the RAID controller module port link status LED and the 

RAID controller module status LED are solid green for each port that is 

connected to a cable. If the LEDs are not solid green, see "Planning: RAID 

Controller Modules" on page 29.

2 Ensure that all the cables are attached correctly according to array mode 

you selected.

3 Turn off the server, storage array, and expansion enclosures. 
4 Reseat the RAID controller module and reconnect cables on the storage 

array and the server.

5 Turn on the expansion arrays and then the storage array and wait until the 

system is fully booted.

6 Turn on the server.
7 Check the link status LED. If the link status LED is not green, replace the 

cables.
If the problem is not resolved, see "Getting Help" on page 253.

8 Reboot the host server.

You must turn off the host server before resetting the cables on 

the storage array or expansion enclosure.

If the problem is not resolved, see "Getting Help" on page 253.

book.book  Page 247  Monday, June 21, 2010  11:00 AM