Pico Macom PSW044-2.0 사용자 설명서

PSW044-2.0

Triggering toolbar

The Triggering toolbar tells the scope device in the selected capture window when to
start capturing data.

Trigger Mode.

None: PicoScope acquires waveforms repeatedly without waiting for
specific events.
Auto: PicoScope tries to wait for a trigger event before displaying
data. If there is no trigger event within a specified time, it displays
data anyway. It repeats this process until you click the 

. "Auto" mode does not set up the trigger level automatically; you

still need to do this yourself.
Repeat: PicoScope waits for a trigger event before displaying data;
but if there is no trigger event, it displays nothing. It repeats this
process until you click the 

.

Single: PicoScope waits once for a trigger event, then stops
sampling. To repeat a single trigger, click the 

.

Trigger Source. This is the channel that PicoScope monitors for
the 

 condition.

Rising Edge. Click to trigger on the rising edge of the waveform.

Falling Edge. Click to trigger on the falling edge of the waveform.

Trigger Level. Sets the 

 level. You can also set the trigger

level by dragging the 

 up or down on the screen.

Pre-trigger Time (0% to 100%). This parameter controls how
much of the waveform appears before the trigger point. It defaults
to 50%, which puts the 

 is in the middle of the

 to the left or right.

Post-trigger Delay. Click this button to toggle the Post-trigger
Delay control (see next item).

Post-trigger Delay. The post-trigger delay is the time that
PicoScope waits after the trigger point before sampling. You can also
modify this parameter by dragging the 

 while the

Post-trigger Delay button is enabled. As you drag the marker,
you will see the 

 displayed briefly. For this

control to have an effect, you must first make sure that the Post-
trigger Delay button is enabled. 

See the reference topic "

" for information on how the Pre-trigger

Time and Post-trigger Delay controls interact.

56

56

56

68

68

16

16

16

16

13

65