Grizzly G0563 사용자 설명서
-10-
Model G0563/G0564 (Mfd. Since 10/11)
No list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Like all machinery there is potential danger
when operating this machine. Accidents are
frequently caused by lack of familiarity or
failure to pay attention. Use this machine
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, serious
personal injury may occur.
Additional Safety for Oscillating Edge Sanders
WORKPIECE PRESSURE. Do not jam the
workpiece against the sanding surfaces. Firmly
grasp the workpiece in both hands and ease it
against the belt/spindle using light pressure.
workpiece against the sanding surfaces. Firmly
grasp the workpiece in both hands and ease it
against the belt/spindle using light pressure.
HAND PLACEMENT. Do not place hands near,
or in contact with, sanding surfaces during opera-
tion.
or in contact with, sanding surfaces during opera-
tion.
WORKPIECE HANDLING. Grip the workpiece
with both hands.
with both hands.
MAINTENANCE. Perform machine inspections
and maintenance promptly as required.
and maintenance promptly as required.
SANDING BELTS/DRUMS. Replace sanding
belts and drums promptly as needed.
belts and drums promptly as needed.
WORKPIECE QUANTITY. Never sand more than
one piece of stock at a time.
one piece of stock at a time.
FOREIGN MATERIAL. Always inspect stock for
nails, staples, knots, and other imperfections that
could be dislodged and thrown from the machine
during sanding operations.
nails, staples, knots, and other imperfections that
could be dislodged and thrown from the machine
during sanding operations.
DUST COLLECTION. Never operate the sander
without an adequate dust collection system in
place and running.
without an adequate dust collection system in
place and running.
DIRECTION. Never sand tapered or pointed stock
with the point facing the feed direction.
with the point facing the feed direction.
POWER DISCONNECT. Disconnect the machine
from the power source before changing the sand-
ing belt or sleeve.
from the power source before changing the sand-
ing belt or sleeve.
TEST RUN. Test run the machine before starting
any work.
any work.