Festool 571579 사용자 설명서

6

min

-1

 

Revolutions per minute

Ø Diameter

  

  Tip, advice

 

L

 

instructions. Failure to follow the warnings and 
instructions may result in electric shock, fi re and/
or serious injury.

The term “power tool” in the warnings refers 
to your mains-operated (corded) power tool or 
battery-operated (cordless) power tool.

1  WORK AREA SAFETY
a)  Keep work area clean and well lit. Cluttered 

and dark areas invite accidents.

b)  Do not operate power tools in explosive atmo-

spheres, such as in the presence of fl ammable 
liquids, gases or dust. Power tools create 
sparks which may ignite the dust or fumes.

c)  Keep children and bystanders away while op-

erating a power tool. Distractions can cause you 
to lose control.

2   ELECTRICAL SAFETY
a)  Power tool plugs must match the outlet. Never 

modify the plug in any way. Do not use any 
adapter plugs with earthed (grounded) power 
tools. Unmodifi ed plugs and matching outlets 
will reduce risk of electric shock.

b)  Avoid body contact with earthed or grounded 

surfaces, such as pipes, radiators, ranges and 
refrigerators.  There is an increased risk of elec-
tric shock if your body is earthed or grounded.

c)  Do not expose power tools to rain or wet condi-

tions. Water entering a power tool will increase 
the risk of electric shock.

d)  Do not abuse the cord. Never use the cord for 

carrying, pulling or unplugging the power tool. 
Keep cord away from heat, oil, sharp edges or 
moving parts. Damaged or entangled cords in-
crease the risk of electric shock.

e)  When operating a power tool outdoors, use an 

extension cord suitable for outdoor use. Use of 
a cord suitable for outdoor use reduces the risk 
of electric shock.

 

Warning of general danger

  Risk of electric shock

  Wear a dust mask!

  Wear ear protection.

  Clean the air vent slits and dust fi lter

  Read the Operating Instructions/Notes! 

V Volts

A Amperes

Hz Hertz

W Watt

~ 

Alternating current

n

0

 

No load speed

 

Class II Construction

rpm

Extension cord  ................................................ 10

Fitting the 

PLANEX ........................................... 10

Electronics ....................................................... 11
Changing sanding pads ................................... 11
Affi xing abrasives ............................................ 12
Adjusting the internal/external extraction ..... 12
Adjusting the suction power ............................ 12
Sanding close to edges .................................... 13
Dust extraction ................................................ 13