Tandberg Data SCSI DLT-V4 Internal Black 7301708700 사용자 설명서

Chapter 2  Installing the Tape Drive

Installing the Internal SCSI Tape Drive

DLT-V4 Product Manual

14

Installing the Internal SCSI Tape Drive

2

This section contains step-by-step instructions for installing the internal 

SCSI tape drive.

2

Installing the tape drive is fast and easy when you follow the instructions 

in this section in the order presented. Complete the following steps, 

covered in the next few sections:

Table 2   Installing the DLT-V4 
Internal SCSI Tape Drive — 
Overview

 

1

Unpack and check the tape drive for shipping 

damage.

2

Select a server or workstation that is to host 

the tape drive.

3

Set the SCSI ID for the tape drive, if you do 

not want to use the factory-set default.

4

Shut down and power off the server or 

workstation that is to host the tape drive. 

Power off all peripheral devices attached to 

the server or workstation.

5

Install an active LVD/SE terminator on the 

SCSI cable if the tape drive is the last or only 

device on the SCSI bus.

6

Remove the cover from the server or 

workstation, as explained in the server or 

workstation’s documentation

7

Install an LVD/SE SCSI host adapter in the 

server or workstation, if necessary.

8

Install the tape drive in an open drive bay.