Porter-Cable PCB270TS 사용자 설명서

–  23  – 

NOTE: The table top surfaces should be cleaned to 

remove the protective coating that it is shipped with 

before using the saw. 

To raise or lower the blade, turn the blade elevation 

handwheel (1) to the desired blade height.

1.  To tilt the saw blade for bevel cutting, loosen the lock 

handle (2) by turning clockwise and turn the tilting 

hand wheel (3).

2.  Tighten the lock handle (2) counterclockwise to 

secure.

The ON / OFF switch has a removable safety key. With 

the key removed from the switch, unauthorized and 

hazardous use by children and others is minimized and 

the saw will not turn on.

1.  Lift the switch cover (1).

2.  To turn the table saw ON, insert the black key (2) into 

the key slot in the center of the switch (3).

3.  Push the key firmly into the slot, then pull switch up 

to the ON position to start  the table saw.

4.  To turn the table saw OFF push the switch to the 

down position. 

NOTE: The switch cover is designed 

to allow the saw to be turned off by pressing on the 

cover either with a hand or knee. 

5.  Remove black safety key when saw is not in use to 

prevent unauthorized usage.

This saw has an overload reset button (1) that resets the 

motor after it shuts off due to overloading or low voltage.

If the motor stops during operation, turn the ON / OFF

switch to the OFF position. Wait about five minutes for 

the motor to cool, push in on the reset button (1) and 

turn the switch to the ON position.

To prevent fire hazard, clean and remove sawdust from 

under the saw frequently.
The sawdust port has a 2-1/2 in. (63.5 mm, O.D.) 

diameter opening, suitable for attaching to a wet/dry 

vacuum hose to help keep the work area free of 

sawdust.

To prevent sawdust buildup inside the saw housing, 

attach a vacuum hose (1) to the dust port (2) at the rear 

of the table saw. DO NOT operate the saw with the hose 

in place unless the vacuum is turned on.

OPERATION

1

2

3

1

2

3

1

1

2