Tandberg Data SCSI DLT-V4 External Black 7302709000 사용자 설명서

Chapter 2  Installing the Tape Drive

Preparing to Install the Tape Drive

DLT-V4 Product Manual

5

interface (SCSI) bus, but you can also attach it to a single-ended (SE) SCSI 

bus.
Make sure the SCSI host adapter or controller supports these 

configurations. If you connect the tape drive to an SE bus, or if there are 

SE devices attached to the same SCSI bus, the tape drive’s performance is 

limited to the maximum data transfer speed and maximum cable lengths 

of the SE bus (usually 40 MB/s). The DLT-V4 is not compatible with a high-

voltage differential (HVD) SCSI bus.

2

If you attach the tape drive to a narrow (50-pin) SCSI bus, you must use a 

customer-supplied 68-pin to 50-pin adapter that terminates the unused 18 

pins. These adapters are sometimes labeled 

.

Make sure the total length of the SCSI bus does not exceed the ANSI SCSI 

standard of 19 feet (6 meters) for an SE SCSI bus, 40 feet (12 meters) for an 

LVD SCSI bus with multiple devices, or 82 feet (25 meters) for an LVD 

SCSI bus with a single device.

2

The DLT-V4 SATA interface tape drive (internal only) incorporates a 

Serial ATA (SATA) bus. 
Make sure the total length of the internal SATA data cable does not 

exceed the SATA standard of approximately 40 inches  (1 meter).