Tandberg Data SCSI DLT-V4 External Black 7302709000 사용자 설명서

Chapter 2  Installing the Tape Drive

Installing the Tabletop SCSI Tape Drive

DLT-V4 Product Manual

8

• Avoid locations near generators, electric motors, audio speakers, or 

other sources of magnetic fields. Magnetic fields can adversely affect 

the tape drive and data cartridges.

2

All SCSI devices attached to the server or workstation must have a 

unique SCSI ID. Check the SCSI IDs on all other devices on the selected 
server or workstation, including the SCSI host adapter, and select an 

unused SCSI ID for the tape drive. The factory default SCSI ID for this 

tape drive is 5, as shown in 

. If the tape drive’s factory default 

SCSI ID is not already in use by another device on the same SCSI bus, you 

do not need to change the SCSI ID.

Figure 1  Rear Panel SCSI 
Tabletop Tape Drive

To set the SCSI ID on the tape drive, use a small screwdriver or ballpoint 

pen to press the button above the SCSI ID switch to select the next lower 

SCSI ID. Press the button below the SCSI ID switch to select the next 

higher SCSI ID. Each time you press one of these buttons, the SCSI ID 

decreases or increases by one. Press the appropriate button until the 

desired SCSI ID appears on the switch display.

If you attach the tape drive to a narrow (50-pin) SCSI bus, you 

can only use IDs 0 through 7.