Festool KS 120 사용자 설명서

The Kapex saw has electronic speed control with soft-start 

circuitry. The electronic controller will maintain the motor 

speed even as the load changes. The speed control is 
infinitely variable from 1400 to 3400 RPM. The optimal 

speed of the saw is predominately determined by the type 

of material being cut. 

Soft wood products and veneer plywoods 

6 

Hardwood products 

3-6 

Plastic laminate countertops 

6 

Hard plastics 

3-5 

Soft plastics 

1-4 

Aluminum 4-6 

Turn the speed control dial to the number shown in the 

table to the left. The speeds listed in the table are just 

rough guidelines, and actual results may vary. 

  

 

CAUTION! Laser Radiation. Do not look 

directly into the laser beam. 

The Kapex saw contains a low-power solidstate laser system 
that scans across the path of the sawblade to indicate to the 

user where the blade will cut the workpiece. (The laser does 

not cut the workpiece.) 

The two laser beams shine down on the workpiece on either 

side of the sawblade. The sawblade will cut the workpiece 

between the two laser lines.  

To turn on the laser, press the On/Off button on the rear of 

the motor near the speed control dial. Pressing the button a 

second time will turn the laser off. The laser will also 

automatically shut off if left on for more than approximately 
30 minutes. 

The power trigger turns on the saw but also releases the 

motor head to plunge downward. To help prevent 
accidental starting of the saw, the trigger lock must be 

pushed to release the trigger to power the saw.  

► 

To start the saw (activate the sawblade), press the 
trigger lock and squeeze the trigger. The saw head can 

then be plunged downward. 

► 

To plunge the saw head down without starting the saw, 
squeeze the power trigger, but do not press the trigger 

lock. 

 

Supplemental User’s Manual 

11