Festool PI561287 사용자 설명서

 

12 

Kapex KS120 Miter Saw 

The hold down clamp fits in a socket on either the left or 

right sides of the saw. To insert or remove the clamp, 

rotate it to the rear to unlock it from the socket, as shown 
in the first image below. To lock the clamp in its socket, 

otate it to the forward position, as shown in the center 

image below. To secure the workpiece, press down on the 

green knob and rotate the locking handle down, as shown 

in the image on the right, below. To release the clamp, 
rotate the locking lever up. 

r 

 

A mitered cut is where the saw head is rotated side-to-

side. The Kapex saw is capable of mitering 50° to the left 
and 60° to the right. Positive stops are located at 0, 22½, 

30, and 45 degrees. The miter gauge pointer also includes 

½ degree vernier indices for accurately setting the miter 
angle to half-degree values. Also refer to “

“ described on page 15. 

1. 

Release the miter lock by lifting up on the handle. 

 

 

2. 

Press down on the miter stop release lever, and rotate 

the miter to the desired angle. 

 

► 

To stop at one of the preset positive lock miter 

positions, release the miter stop lever just before 

reaching the angle, and the miter stop will click as it 
locks into position. 

► 

To set the miter angle to ½ degree between the 

primary angles, line up the ½° vernier indices with 
the adjacent angle index marks. (The example 

shown to the left represents 20½°.)  

3. 

When the desired miter angle is set, engage the miter 

lock by pressing down on the miter lock lever. 

 

Note: When setting a miter angle very close to 

one of the miter stops (for example, at 45½° ), 

keep holding down the miter stop release lever 
until you fully engage the miter lock lever, to 

prevent the miter angle from jumping to the 

nearby miter stop position.