Festool PI561287 사용자 설명서

 

WARNING! To reduce the risk of injury from 

contact with a moving part, always unplug the 
saw before changing blades. 

1. 

Push in and rotate the FastFix

®

 arbor lock clockwise. 

This prevents the arbor from turning and also disables 

the motor. 

2. 

Loosen the clamping screw on the arbor bolt guard, 
and rotate the guard away from the arbor bolt. (The 

combination hex key is stored on the back of the saw 

by the power cord.) 

 

3. 

Unscrew the arbor bolt by turning it clockwise. The 

arbor bolt is a left-hand thread and turns the 

opposite of a standard screw. 

 

4. 

Without pushing down on the trigger lock, pull up on 

the trigger to release the blade guard. 

5. 

Raise the blade guard out of the way and remove the 

outboard arbor flange and sawblade from the arbor. 

6. 

Inspect the friction lining on the two arbor flanges. If 

the lining is damaged, replace the flanges, as this can 
cause the sawblade to wobble. 

 

Note: The friction lining on the arbor flanges 

grips the blade, but also permits the blade to slip 
slightly, in the event of a binding condition. 

 

 

WARNING! When installing a new blade, make 

sure the arbor bolt is properly tightened and the 
rotation direction of the sawblade matches the 

rotation direction indicated on the saw (see image 

below). 

7. 

Make sure the blade is oriented correctly and install 

the blade onto the inboard arbor flange. 

8. 

Replace the outboard arbor flange, tighten the arbor 
bolt, and then unlock the FastFix arbor lock. 

 

Supplemental User’s Manual 

9