Festool PS 300 EQ 사용자 설명서

5

Plywood, chip board:  

6

Wood fi berboard:  

4-6

Plastics:  

3-6

Ceramic:  

3-5

Aluminum, NF metals:  

3-5

Steel:  

2-4

4.1

In order to cut different materials with an optimum 

feed movement, these pendulum jigsaws have an 

adjustable pendulum stroke. Select the desired 

setting with the pendulum stroke switch [4.1]:
Setting 0 = pendulum stroke off
Setting 3 = maximum pendulum stroke
Recommended pendulum stroke settings: 
Hard and soft wood: 

1-3

Wood core plywood, plywood: 

1-2

Chipboard, wood fi berboard: 

1-3

Plastics: 1-2
Ceramic: 0
Aluminum, NF metals: 

0-2

Steel:  

0-1

5.1

5.2

5.3

5.4

The base runner can be swiveled to both sides by 

up to 45° for bevel cuts:
- Turn off and unplug tool.
- Remove chip guard and splinterguard.

- Release locking screw [5.1] with Allen key.
- Push base runner approx. 5 mm (1/5") for-

wards.

- Set desired inclination according to the scale 

[5.4].

- Tighten locking screw [5.1].

The base runner can be moved back for sawing 

close to edges.

- Turn off and unplug tool.
- Remove chip guard and splinterguard.
- Release locking screw [5.1] with Allen key.
- Push base runner to rear position so that the 

centering pin [5.2] fi ts in the opening [5.3].

- Tighten locking screw [5.1].

6.2

6.1

The splinterguard allows cuts with splinter-free 

edges, even on the exit side of the sawblade.
- With the tool switched off and unplugged, fi t the 

splinterguard [6.1] on the guide [6.2] up to the 

sawblade.

- Switch the jigsaw on and with the tool running, 

use the tool to push the splinterguard in and cut 

on a level surface until the splinterguard is fl ush 

with the front edge of the base runner. 

Note: The splinterguard must lie close to the 

sawblade on both sides to ensure reliable opera-

tion. Thus, a new splinterguard should be fi tted 

every time the sawblade is changed to ensure 

splinter-free cuts.

7.1