John Deere ET-3403-J 사용자 설명서
10-Inch Compound Miter Saw Operator's Manual
15
Operation
PRE-OPERATION (CONTINUED):
4.
Oblique angle:
Before the power tool is shipped from the factory, it is adjusted for 0° and left 45° bevel cutting angles. The
positioning and bevel cutting angle can be adjusted by changing the height of the 8 mm bolt. (Maximum bevel
cutting angle is 45°).
Before the power tool is shipped from the factory, it is adjusted for 0° and left 45° bevel cutting angles. The
positioning and bevel cutting angle can be adjusted by changing the height of the 8 mm bolt. (Maximum bevel
cutting angle is 45°).
5.
Securing the workpiece:
WARNING:
ALWAYS CLAMP OR VISE, TO SECURE THE WORKPIECE TO THE FENCE;
OTHERWISE THE WORKPIECE MIGHT BE THRUST FROM THE TABLE
AND CAUSE BODILY HARM.
OTHERWISE THE WORKPIECE MIGHT BE THRUST FROM THE TABLE
AND CAUSE BODILY HARM.
6.
Installing the holders:
The holders help keep longer workpieces stable and in place during the cutting operation.
a.
The holders help keep longer workpieces stable and in place during the cutting operation.
a.
As indicated in Fig.11, use a steel square for aligning the upper edge of the holders with the base surface.
b.
After aligning, secure the holders with the 6mm wing bolts.
7.
Stopper for precision cutting:
The stopper facilitates continuous precision cutting in lengths of 10" to 16-1/2" (255mm to 420mm). To install
the stopper, attach it to the holder with the 6mm wing bolt as shown in Fig. 12.
The stopper facilitates continuous precision cutting in lengths of 10" to 16-1/2" (255mm to 420mm). To install
the stopper, attach it to the holder with the 6mm wing bolt as shown in Fig. 12.
(Fig. 9)
(Fig. 10)
(Fig. 11)
(Fig. 12)