KUHN RIKON 10" Cabinet Saw Sliding Table 사용자 설명서

1. Insert the support arm into the swing arm 
extension bar as shown (A, Fig. 9) making sure 
that bearing assembly rests between the adjusting 
nuts and the swing arm extension bar (B, Fig. 9).

Reminder: Tighten the carriage bolts shown in 
Figure 8 on page nine once the support arm is 
installed.

2. Hold the support arm in place by installing the 
second bearing set and adjusting nuts as shown. 
The second set of bearings should be installed 
against the bottom side of swing arm extension 
bar. Figure 10.

NOTE: Do not overtighten the adjusting nuts as 
the bearings will bind and the table will not slide 
smoothly.

3. Hold the sliding table carriage against the 
sliding table and install the lock knobs through 
the carriage to the T-nuts bar in the sliding table 
channel. Figure 11.
   

4. Line up the two holes in the side of the support 
arm with the two holes in the side of the sliding 
table carriage (Fig. 12). 

5. Insert the two locking knobs with the long 
threaded ends as well as two 6MM washers 
through the support arm and through the sliding 
table carriage (Fig. 12). Attach with with two 6MM 
washers and two 6MM hex nuts. 

10