Bosch 4100-09 사용자 설명서
28.
FIG. 8
4
5
FIG. 9
7
9
9
10
8
ATTACHING THE GUARD ASSEMBLY
8. With one hand, hold the front of the barrier guard assembly
4
by the metal “fork”. With the other hand, hold the guard
release lever
release lever
5 up (Fig. 7).
9. Lower the rear of guard assembly and slip the cross bar
6 into
the rear notch
7 on top of the riving knife 2 (Fig. 7).
10. Lower the front of the guard assembly
4 until the metal “fork”
is parallel with the table (Fig. 8).
11. Press down on the guard release lever
5 until you feel and
hear it snap into the locking position. Check that the guard
assembly is securely connected (Fig. 8).
assembly is securely connected (Fig. 8).
ATTACHING THE ANTI-KICKBACK DEVICE
12. Attach the Anti-Kickback Device
7 into the flat recessed
area
8 of the riving knife 2 (Fig. 9).
13. Squeeze the compression pads
9 while nesting the device
into the flat area (Fig. 9).
14. Release the compression pads such that the Anti-Kickback
Device locks onto the riving knife immediately behind the
guard assembly. Check that the attachment pin is securely
connected into locking hole. Carefully raise and lower the
pawls
guard assembly. Check that the attachment pin is securely
connected into locking hole. Carefully raise and lower the
pawls
10 – when letting go, the spring-loaded pawls must
come down and contact the table insert (Fig. 9).
Hint: Position the Anti-Kickback Device behind the flat recessed
area and slide it towards the front until it drops into the recessed
area – then release the compression pins.
area and slide it towards the front until it drops into the recessed
area – then release the compression pins.
Note: The two attachments are independant of each other, so
the Anti-Kickback Device can be attached before the Guard
Assembly.
the Anti-Kickback Device can be attached before the Guard
Assembly.
FIG. 7
4
5
7
6
2
2