Intel SERVER CHASSIS SR2500 SR2500 사용자 설명서

Intel® Server System SR2500AL 

 

For system configurations that require either a Tape Drive or a 6

th

 hard disk drive, a dual 

purpose drive bay is provided.  By default this drive bay is covered by two face plates as shown 
in the following diagram.  The drive bay is located next to the control panel.  

TP02108

 

To configure a 6

th

 hard drive, the lower face plate is removed and the 6

th

 hard drive accessory 

kit is installed (product order code – ASR2500SIXDRV). This kit includes a backplane board 
insert, power cable, and drive carrier. 

To install a 3.5” tape drive, both face plates are removed and the optional tape drive kit is 
installed (product order codes – ASR2500SATAPE or ADRTAPEKIT). Both tape drive kits 
include tape drive mounting tray and necessary cables. 

Note: To remove the tape drive tray from the chassis, a spring latch located inside the chassis 
on the back right side of the carrier must be released to allow the drive tray to slide free. Do not 
attempt to pull out the drive tray without first releasing the spring latch. Doing so may damage 
the plastic faceplate. 

 

TP02105

TP02092