Delta 20-400 사용자 설명서

12

Make sure that the switch is in the 

“OFF" position before plugging cord 

into outlet. Do not touch the plug’s metal prongs when 

unplugging or plugging in the cord

Do not attempt to operate this tool 

without first connecting it to an 

adequate dust collection system
NOTE: The DELTA

®

 14" Steel Frame Band Saw uses 

a Safety Key (A), shown in Figure 12. The Safety Key 

must be in place in order to operate the machineBefore 

attempting to turn on the band saw, ensure the Safety 

Key is installed. 
The power switch is located on the left side of the 

machine. To turn the machine "ON", ensure the yellow 

safety key is installed and lift the red power switch (B) 

To turn the machine "OFF", press up on the red power 

switch.

In the event of a power outage (such as 

a breaker or fuse trip), always move the 

switch to the “OFF" position until the main power is 

restored.

When the tool is not in use, the switch should be 

locked in the “OFF" position. This can be done by 

grasping the Safety Key (A), shown in Figure 12 above, 

and pulling it out of the switch. With the Safety Key 

removed the switch will not operate. Should the Safety 

Key be removed while the machine is running, the 

switch can be turned “OFF" once, but cannot be 

restarted without inserting the Safety Key.
IMPORTANT: Store the Safety Key away from the tool 

to prevent unauthorized use

Your DELTA

®

 14" Steel Frame Band Saw has two 

cutting speeds: low (1620 ft./min )and high (3340 ft./

min). The cutting speed is determined based on which 

of the two pulley wheels, shown in Figure 13 is in use. 

The larger diameter pulley wheel (A) is used for the 

lower cutting speed while the smaller diameter wheel 

(B) is used for the higher speed. 

•  To change the cutting speed, open the lower wheel 

guard (C).

•  Refer to the diagram and instructions (D) posted on 

the inside of the wheel guard.

•  Reduce tension on the pulley belt using the belt 

tensioning knob (E). 

•  Place belt on the proper wheels and hand turn to 

ensure it tracks in the center of both wheels. 

•  Re-tension pulley belt using the belt tensioning knob.
•  Close the lower wheel guard.