Woodstock W1829 사용자 설명서

-23-

Model W1829 (Mfg. Since 9/11)

ATIO
NS

Edge Jointing

The purpose of edge jointing is to produce a finished,

flat-edged surface that is suitable for joinery or finishing

(see

Figure 32). It is also a necessary step when squaring

rough or warped stock.

To edge joint on the jointer, do these steps:

1. Read and understand SAFETY, on Page 6.

2. Inspect your stock for dangerous conditions as

described in the

Stock Inspection & Requirements

instructions, on

Page 20.

3. Set the cutting depth for your operation.

Note: Between

⁄

" and

⁄

" for edge jointing, using

a more shallow depth for certain species or for wide

stock.

4. Make sure the fence is set to 90˚.

5. If your workpiece is bowed (warped), place it so

the concave side is face down on the surface of the

infeed table.

6. Start the jointer.

7. Press the workpiece against the table and fence with

firm pressure. Use your trailing hand to guide the

workpiece through the cut, and feed the workpiece

over the cutterhead (see

Figure 33).

Note: If your leading hand gets within 4" of the

cutterhead, lift it up and over the cutterhead, and

place it on the portion of the workpiece that is

over the outfeed table. Focus your pressure on the

outfeed end of the workpiece while feeding, and

repeat the same action with your trailing hand if it

gets within 4" of the cutterhead. Keep your hands

safe—DO NOT let them get closer than 4" from the

cutterhead!

8. Repeat Step 7 until the entire edge is flat.

Figure 33. Typical edge jointing operation.

Figure 32. Illustration of edge jointing

results.

Portion

Removed with

Jointer

If you are not experienced with a

jointer, set the depth of cut to 0", and

practice feeding the workpiece across

the tables as described below. This

procedure will better prepare you for

the actual operation.