Bostitch T55 사용자 설명서

-10-

O-ring cut or cracked

Replace O-ring

O-ring/seals cut or cracked

Replace trigger valve assembly

Loose nose screws

Tighten and recheck

O-ring or Gasket is cut or cracked

Replace O-ring or gasket

Bumper cracked/worn

Replace bumper

Damaged gasket or seal

Replace gasket or seal

Cracked/worn head valve bumper

Replace bumper

Loose cap screws

Tighten and recheck

Air supply restriction

Check air supply equipment

Tool dry, lack of lubrication

Use STANLEY-BOSTITCH Air Tool Lubricant

Worn head valve O-rings

Replace O-rings

Broken cylinder cap spring

Replace cylinder cap spring

Head valve stuck in cap

Disassemble/Check/Lubricate

Tool dry, lacks lubrication

Use STANLEY-BOSTITCH Air Tool Lubricant

Broken cylinder cap spring

Replace cap spring

O-rings/seals cut or cracked

Replace O-rings/seals

Exhaust blocked 

Check bumper, head valve spring, muffler

Trigger assembly worn/leaks

Replace trigger assembly

Dirt/tar build up on driver

Disassemble nose/driver to clean

Cylinder sleeve not seated correctly
on bottom bumper

Disassemble to correct

Head valve dry

Disassemble/lubricate

Air pressure too low

Check air supply equipment

Worn bumper

Replace bumper

Tar/dirt in driver channel

Disassemble and clean nose and driver

Air restriction/inadequate air flow through
quick disconnect socket and plug

Replace quick disconnect fittings

Worn piston O-ring

Replace O-ring, check driver

Tool dry, lacks lubrication

Use STANLEY-BOSTITCH Air Tool Lubricant

Damaged pusher spring

Replace spring

Low air pressure

Check air supply system to tool

Loose magazine nose screws

Tighten all screws

Fasteners too short for tool

Use only recommended fasteners

Bent fasteners

Discontinue using these fasteners

Wrong size fasteners

Use only recommended fasteners

Leaking head cap gasket

Tighten screws/replace gasket

Trigger valve O-ring cut/worn

Replace O-ring

Broken/chipped driver

Replace driver (check piston O-ring)

Dry/dirty magazine

Clean/lubricate use STANLEY-BOSTITCH
Air Tool Lubricant

Worn magazine

Replace magazine

Driver channel worn

Replace nose/check door

Wrong size fasteners

Use only recommended fasteners

Bent fasteners

Discontinue using these fasteners

Loose magazine/nose screws

Tighten all screws

Broken/chipped driver

Replace driver

Feed piston dry

Add STANLEY-BOSTITCH Air Tool Lubricant  
in hole in feed piston cover

Feed piston O-rings cracked/worn

Replace O-rings/check bumper and spring.
Lubricate assembly.

Check Pawl binding

Inspect Pawl and spring on door.
Must work freely.

Canister bottom not set correctly

Set canister bottom for length of nails
being used

Broken weld wires in nail coil

Remove coil of nails and use another coil

Wrong size fasteners for tool

Use only recommended fasteners/check canister
bottom adjustment

Broken welded wires in nail coil

Remove coil of nails and use another coil

Wrong slide plate adjustment for
wire/plastic collated nail coil

Adjust switch pins for wire/plastic collated nail coil