Troy-Bilt TB525CS 사용자 설명서

This operator's manual describes safety and international symbols and pictographs that may appear on this product.  Read the operator's
manual for complete safety, assembly, operating, maintenance, and repair information.

Indicates danger, warning or caution. May be used in
conjunction with other symbols or pictographs.

Do not touch a hot muffler or cylinder. You may get
burned. These parts get extremely hot from operation.
When turned off they remain hot for a short time.

Read the operator’s manual(s) and follow

all warnings and safety instructions. Failure to do so can
result in serious injury to the operator and/or bystanders.

Thrown objects and loud noise can

cause severe eye injury and hearing loss. Wear eye
protection meeting ANSI Z87.1-1989 standards and
ear protection when operating this unit. Use a full face
shield when needed.

Keep all bystanders, especially children

and pets, at least 50 feet (15 m.) from the operating area.

Small objects can be propelled at high

speed, causing injury. Keep away from the rotating rotor.

1. • FULL choke position

2. • PARTIAL choke position

3. • RUN choke position

Always use clean, fresh unleaded fuel

Refer to operator’s manual for the proper type of oil.

ON / START / RUN

OFF or STOP

Sharp blade on cutting attachment

shield.  To prevent serious injury, do not touch the line
cutting blade.

• Avoid accidental starting. Be in the starting position whenever pulling

the starter rope. The operator and unit must be in a stable position
while starting. Refer to Starting/Stopping Instructions.

• Use the right tool. Only use this tool for its intended purpose.
• Do not overreach. Always keep proper footing and balance.
• Always hold the unit with both hands when operating. Keep a firm grip

on both handles or grips.

• Keep hands, face, and feet at a distance from all moving parts. Do not

touch or try to stop the cutting attachment when it rotates.

• Do not touch the engine, gear housing or muffler. These parts get

extremely hot from operation, even after the unit is turned off.

• Do not operate the engine faster than the speed needed to cut, trim or

edge. Do not run the engine at high speed when not cutting.

• Always stop the engine when cutting is delayed or when walking from

one cutting location to another.

• If you strike or become entangled with a foreign object, stop the engine

immediately and check for damage. Do not operate before repairing
damage. Do not operate the unit with loose or damaged parts.

• Stop the unit, switch the engine to off, and disconnect the spark plug

for maintenance or repair.

• Use only original equipment manufacturer replacement parts and

accessories for this unit. These are available from your authorized service
dealer. Use of any unauthorized parts or accessories could lead to
serious injury to the user, or damage to the unit, and void your warranty.

• Keep unit clean of vegetation and other materials. They may become

lodged between the cutting attachment and shield.

• To reduce fire hazard, replace a faulty muffler and spark arrestor. Keep

the engine and muffler free from grass, leaves, excessive grease or
carbon build up.

OTHER SAFETY WARNINGS
• Never store a fueled unit inside a building where fumes may reach an

open flame or spark.

• Allow the engine to cool before storing or transporting. Be sure to

secure the unit while transporting.

• Store the unit in a dry area, locked up or up high to prevent

unauthorized use or damage, out of the reach of children.

• Never douse or squirt the unit with water or any other liquid. Keep

handles dry, clean and free from debris. Clean after each use, see
Cleaning and Storage instructions.

• Keep these instructions. Refer to them often and use them to instruct

other users. If you loan someone this unit, also loan them these
instructions.