Moxa Technologies AWK-1200-AP 사용자 설명서
MOXA AirWorks AWK-1200-AP User’s Manual
Getting Started
2-2
First Time Installation and Configuration
After unpacking the system, make sure the following items are present and in good condition.
Refer to pictures below to see what each item looks like.
Refer to pictures below to see what each item looks like.
1. AWK-1200-AP
2. Power cord
3. 48 VDC, 0.38A Inline Power Injector (PoE)
4. 30 m RJ45 CAT-5 Ethernet cable
5. 1.8 m RJ45 CAT-5 cross-over cable
6. 3 m grounding wire
7. Document and Software CD
8. Wall/mast mounting kit
9. Screws
10. Two 5 dBi Omni-type antennas (N-type connector)
2. Power cord
3. 48 VDC, 0.38A Inline Power Injector (PoE)
4. 30 m RJ45 CAT-5 Ethernet cable
5. 1.8 m RJ45 CAT-5 cross-over cable
6. 3 m grounding wire
7. Document and Software CD
8. Wall/mast mounting kit
9. Screws
10. Two 5 dBi Omni-type antennas (N-type connector)
1. AWK-1200-AP
2. Power cord
3. PSE Injector
4. 30 m cable
5. 1.8 m cable
6. Grounding wire
7. CD
8. Wall mount
9. Screws
10. Antenna
Locating the Data Input and PoE Ports
After unpacking the system, locate the following ports on the AWK-1200-AP unit. The numbers
next to each item refer to the pictures in Figure 2-1.
next to each item refer to the pictures in Figure 2-1.
Interface on the AWK-1200-AP Unit
y Ethernet Port 1: for connecting the 30 m RJ45 CAT-5 Ethernet cable.
Interface on the Inline Power Injector
y Data Input Port 2: for connecting the cross-over Ethernet Cable to a PC or straight-through
Ethernet cable to a Hub, Switch, or Router.
y DC Input Port 3: power adaptor; 48V, 0.38A DC input.
y Power & Data Output Port 4: for connecting the 30 m RJ45 CAT-5 Ethernet cable.
y Power & Data Output Port 4: for connecting the 30 m RJ45 CAT-5 Ethernet cable.