Snapper SPA520 사용자 설명서

 

 

IMPORTANT: Pulling backward on both Traction Controls 
back past Neutral position will cause the machine to back 
up. 
 
1.  Pull back on both Traction Controls simultaneously 

towards handle bar.  Manually engage the Neutral 
Latch Lever.  See Figure 3.2. 

 

 

 
2.  Move Blade Clutch Control Switch to OFF position. 
3.  Move Throttle Control to SLOW (Turtle) Position. 
4.  Stop Engine by turning Keyswitch to STOP position.  

Always park machine on level surface. 

 

3.3.1. ENGINE - START ENGINE AS FOLLOWS: 
1.  Turn Fuel Tank Shut-Off Valve ON. 
2.  Move Blade Clutch Control Switch to OFF position. 
3.  Be sure Right Hand and Left Hand Traction Controls 

are latched in NEUTRAL position. 

4.  Pull Choke Control Knob, if so equipped, (shown 

attached to Fuel Tank and Handle Support Bracket on 
Left Hand side of machine) all the way out to CHOKE 
position.  See Figure 3.3. 

5.  Move Throttle Control to “FAST/CHOKE” position, if so 

equipped.  See Figure 3.4. 

6.  (Manual Start Models) Turn Keyswitch to RUN position. 
7.  (Manual Start Models) Pull Starter Rope until Engine 

starts. 

8.  (Electric Start Models) Turn key to the “START” position 

until engine starts. NOTE:  If after 5 seconds of 
cranking the engine and it does not start, release the 
key, make sure the blade switch control is in the OFF 
position and traction controls are latched in the neutral 
position. Attempt starting again after waiting for 
approximately 20 seconds. 

9.  Push Choke Control Knob all the way in and move 

Throttle Control to “FAST” position.