Smeg PGA95FSC3 사용자 설명서

 

 

 

Create an opening with the dimensions 
shown in the figure in the work surface, 
observing a minimum distance of  50 mm 
from the rear edge. 
The lower part of the protective cover 
must be fully accessible when the 
appliance is installed. This appliance can 
be installed next to walls that are higher 
than the work surface, as long as the 
distance "X" is kept, as shown in the 
figure, to avoid damage from overheating. 

1) 

Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf 
that may be installed directly above them. This type of appliance also requires a cut 3 
mm deep in the work-top with the dimensions shown in figure 4 (detail A, figure 2). 
Before positioning the hob, position the adhesive sponge material “E” supplied over 
the milled surface (fig. 2). Now place the hob on the cut in the work-top and use the 
screws and fixing brackets (sequence shown in Fig. 3) to secure the hob to the 
supporting structure, adjusting it until perfectly horizontal. Do not fit the brackets 
shown in fig. 3 until the hob has been set in place. 

2) 

     

3)

 

4) 

Mill to this depth for laminated worktops of less
than 3mm thickness.