Smeg SCB60GX 사용자 설명서

다운로드
페이지 28
 
 
Instruction for the user 
 
21
 
 
 
7  USE OF THE OVEN 
 
   
 
 
For those models with electronic programmer, before using the oven make sure that the 
display shows the symbol 
.  
For those models with analogue clock and timer, place on the symbol 
 
   
 
 
7.1  Warnings and general advice 
 
   
 
  Using the oven and the grill for the first time, heat them to the maximum temperature (260°C for 
electric oven and 275°C for gas oven) for as long as it takes to burn off any production oil residues 
which could give a nasty flavour to the food. After a power cut, the oven display will flash 
intermittently and show 
. To adjust refer to paragraph "8 ELECTRONIC PROGRAMMER (ONLY 
 
 
 
 
 
  The oven accessories which may come into contact with food are made from materials which 
conform to the standing directives. 
 
 
 
 
WARNING: the gas oven is lit with the door open. The oven is equipped 
with a safety system which stops the burners being lit when the door is 
closed. If this is done wrongly, open the door and wait for a few moments 
before lighting once more. 
 
 
 
 
To prevent any steam in the oven creating problems, open the door in two 
stages: half open (5 cm approx.) for 4-5 seconds and then fully open. To 
access food, always leave the door open as short a time as possible to prevent 
the temperature in the oven from falling and ruining the food. 
 
   
  
7.2  Cooling system 
 
 
The oven is equipped with a cooling system which automatically comes on upon a few minutes after 
the oven has been turned on. 
Fans cause a steady outflow of air from above the door which may continue for a brief period of time 
even after the oven has been turned off. 
 
   
 
 
7.3  Use of the gas oven 
 
   
 
  7.3.1 
Electronic spark lighting 
 
 
 
 
  Open the oven door completely, press the thermostat knob and turn it clockwise 
to max. temperature. The electronic spark lighting device will be enabled 
automatically. Once the oven is lit, hold the knob down for a few seconds to 
allow the thermocouple to heat up. 
This device should not be enabled for more than 15 seconds; if after this time 
the burner has not come on, stop, fully open the oven door and try again after 
one minute. 
 
  7.3.2 
Manual lighting 
 
 
 
 
Open the oven door completely and turn the thermostat knob. Place a 
lit match to the mouth of the flame pipe A in the centre of the oven 
floor and press the thermostat knob. Once the oven is lit, hold the knob 
down for a few seconds to allow the thermocouple to heat up and 
check that the oven is lit through the inspection hole B. Choose the 
cooking temperature by turning the knob clockwise to the desired 
temperature, between 50° and 275°C. 
 
   
 
  If the burner is accidentally switched off, turn the knob to the off position ( ) and wait for one minute 
before lighting again.