Quadra-Fire 7068-112 사용자 설명서

R

August 19, 2011

Page 13

7068-112

Vacuum inside

Exhaust Venting

The  amount  of  ash  buildup  in  the  firepot  will  be  a  good

guide  to  determine  how  often  you  should  clean  the  heat

exchangers.

Heat exchanger cleaning rods may be warm

to the touch. For safety purposes wear

gloves.
Do not pull heat exchanger cleaning rods

while appliance is operating.
Push cleaning rods IN when done, DO NOT

leave cleaning rods OUT. Injury can occur.

7.  Cleaning Heat Exchanger Chambers & Drop Tube
•  Frequency: Weekly or every 15 bags or more fre

quently depending on ash build-up

•  By: Homeowner

9.  Cleaning the Exhaust Path
•  Frequency: Every 25 bags or monthly or more fre

quently depending on ash build-up.

•  By: Homeowner
 a. Appliance must be completely cool.
 b.  Open  cast  hinge  face.    Remove  baffle  and  right

brick and thoroughly vacuum the area and continue

throughout the rest of the firebox.

 c.  Replace right brick and baffle and close cast hinge

face.

10. Cleaning the Hopper
•  Frequency: Monthly or after burning 50 bags of fuel

•  By: Homeowner

After burning approximately 1 ton of fuel you will need

to clean the hopper to prevent sawdust build-up.
A  combination  of  sawdust  and  pellets  on  the  auger

reduces the amount of fuel supply to the firepot. This

can result in nuisance shutdowns and mis-starts.

 a.  The  appliance  must  be  in  complete  shutdown.

Allow the appliance to completely cool down.

b.  Empty the hopper of any remaining pellets.

c.  Vacuum the hopper and feed tube.

a. Allow the appliance to completely cool down before

pulling the cleaning rods.

  Turn the thermostat on and

then immediately off to start the exhaust blower on its

cycle time. It will pull fly ash out the exhaust instead

of into the room.

 b.  Locate the 2 exposed rods directly underneath the heat

exchanger tubes.

 c. To  clean,  pull  the  rods  straight  out  until  it  stops,

approximately 203mm. Slide the rods OUT and IN a

couple of times.

Cleaning 

Rods

10 Heat Exchanger Tubes

8.  Door Latch Inspection
•  Frequency: Prior to heating season or monthly during

heating season

•  By: Homeowner
The door latch is non-adjustable but the gasketing between

the glass and firebox should be inspected periodically to make

sure there is a good seal.